A JA-2SD HANDSFREE SUB MASTER STATION HANDSFREE SUB MASTER STATION HANDSFREE SUB MASTER STATION HANDSFREE SUB MASTER STATION HANDSFREE SUB MASTER STATION JA-2SD INSTALLATION & OPERATION MANUAL MANUEL D’INSTALLATION ET D’UTILISATION EINBAU- & BEDIENUNGSANLEITUNG MANUAL DE INSTALACION Y OPERACION INSTALLATIE- EN BEDIENINGSHANDLEIDING -1-
* Places where the temperature is quite low, such as inside a refrigerated areaor in front of air-conditioner. General Prohibitions PRECAUTIONS GENERALES Prohibition to Dismantle the Unit Prohibition on Subjecting the Unit to Water 1. This unit is for indoor use only. Do not use outdoors. 2. In areas where broadcasting station antennas are close by, the intercom system may be affected by radio frequency interference. 3. If a cellular phone is used close by, the unit may malfunction. 4.
PRECAUCION INSTALLATION INSTALLATION EINBAU INSTALACIÓN INSTALLATIE (No seguir estas instrucciones podría causar daños físicos o materiales) 1. Before turning on the power, make sure wires are not crossed or shorted. Fire or electric shock could result. 2. When mounting the unit on wall, install the unit in a convenient location, but not where it could be jarred or bumped. Injury could result. 3. While the power supply is turned on, do not make any wiring connections.
Deutsch WIRING Wiring method Wire the inside stations in a station-to-station manner. NAMES NOMES BEZEICHNUNGEN NOMBRES BENAMINGEN Cable 1. Parallel cable or single-sheathed cable are recommended. Vinyl jacket, PE(polyethylene) insulation cable is recommended. 2. Never use loose wires, twisted pair cable or coaxial cable. 3. When using existing wires, which may contain unused wires, it is suggested to terminate both ends of unused pair(s) with a 120Ω resistor.
NAMES & FUNCTIONS [1] Speaker [2] Door call-in LED (Door 1) [3] Door call-in LED (Door 2) [4] Room CALL button [5] DOOR RELEASE button [6] Mic. [7] TALK button [8] Transmit LED [9] Door call-in selector: 1, 2 or 1&2 [10] Chime TONE volume control Deutsch NAMES & FUNCTIONS [1] Speaker [2] Door call-in LED (Door 1) [3] Door call-in LED (Door 2) [4] Room CALL button [5] DOOR RELEASE button [6] Mic.
3-2 WIRING CABLAGE VERDRAHTUNG ALAMBRADO AANSLUITING English MOUNTING 1. Push RELEASE button (to unlock or to insert the wire securely). 2. Insert the cable into terminal. [1] Screw (x2) [2] Wall mounting bracket [3] Single-gang box English WIRING Impedance matching switch Terminate farthest sub station, putting SW. to ON position, otherwise both image and audio are deteriorated. Français MOUNTING 1. Push RELEASE button (to unlock or to insert the wire securely). 2. Insert the cable into terminal.
Español Answering a door call (AUTO mode) 1. Momentarily depress CALL button. 2. Chime tone sounds and caller’s voice is heard. Door call-in LED is lit for DOOR 1, or DOOR 2. 3. Press for a moment TALK button and reply handsfree. 4. Press once TALK button at the end. NOTES: Call-in timer; 45 sec. (approx.) Communication timer; 1 min. (approx.) Press TALK button to manually turn on again (within 30 sec. after communication).
Français Answering a door call (MANUAL mode) 1. Momentarily depress CALL button. 2. Chime tone sounds and caller’s voice is heard. Door call-in LED is lit for DOOR 1 or DOOR 2. 3. Depress and hold down TALK button for 1 sec. or more. 4. To transmit, talk while pressing TALK button, and to listen, release TALK button. 5. At the end, press once TALK button. NOTES: Call-in timer; 45 sec. (approx.) Communication timer; 1 min. (approx.) Press TALK button to manually turn on again (within 30 sec.
Nederlands Activating Door Release 1. Depress and hold down DOOR RELEASE button. 2. The door is unlocked. NOTES: Not available in standby mode. 5-6 5-5 English Transfer door call 1. While answering door, press CALL (Room call) button. After sounding a pretone, speak to the rest station(s). 2. At the called station(s), a pretone sounds, and both image and audio of door are activated. 3. Transferred station answers by pressing once TALK button. To end, press TALK button again.
Nederlands Transfer door call 1. While answering door, press CALL (Room call) button. After sounding a pretone, speak to the rest station(s). 2. At the called station(s), a pretone sounds, and both image and audio of door are activated. 3. Transferred station answers by pressing once TALK button. To end, press TALK button again. (The channel with door station is held approx. 45 sec.) 4. Communicate with door station after pressing TALK button. Lastly, press TALK button for standby.
Español TECHNICAL PRECAUTIONS * Operating temperature: 0°C ~ 40°C (+32°F ~ +104°F). * Cleaning: Clean the units with a soft cloth dampened with neutral household cleanser. Do not use any abrasive cleaner or cloth. * In case of system malfunction, turn off the power switch at master station. If this doesn't solve the problem, shut DC power down, and contact a qualified technician. Español Supplied from master station (DC18V). (MAX) 120mA. • Consumption: Chime tone, 30 sec. approx.
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which examination shall disclose to be defective and under warranty.
