EFD.qxd 08.1.
EFD.qxd 08.1.18 4:18 PM ページ 2 PRECAUTIONS Français English General Prohibitions Prohibition to Dismantle the Unit Prohibition on Subjecting the Unit to Water WARNING GENERAL PRECAUTIONS (Negligence could result in death or serious injury.) 1. Keep the unit more than 1 m away from radio or TV set. 2. This unit is for indoor use only. Do not use outdoors. 3. In areas where broadcasting station antennas are close by, the intercom system may be affected by radio frequency interference. 4.
EFD.qxd 08.1.18 4:18 PM ページ 3 2 INSTALLATION 2-1 Mounting locations 2 The master monitor station and sub 1 Install the master monitor station and 3 Allow 15 cm (6") or more of vertical open space monitor station have switches on both sides. Allow at least 5 cm (2") of open space on either side. from the center of the mounting bracket in order to mount the master monitor station and sub monitor station.
EFD.qxd 08.1.18 4:18 PM ページ 4 3 WIRING Insert wires securely into each terminal as shown. English DOOR 1 Video door station JF-2MED AIPHO NE JF-DA Master monitor station JF-DA AIPHONE JF-DVF AIPHON E JF-DV JF-DV JF-DVF #2 #1 Français A1 A2 2 Nederlands NP DOOR 2 AIPHO NE JF-DA JF-DA AIPHONE JF-DVF AIPHON E JF-DV JF-DV JF-DVF P JF-D (Audio only) Setting is required.
EFD.qxd 08.1.18 4:18 PM ページ 5 JF-2HD Sub monitor station Option connector JF-2HD Sub monitor station (BR) (RD) (OG) SW (YE) SW (GR) (BL) PK (PR) FS (GY) (WH) E #3 [5] [6] English #3 [2] #3 To prevent shorts, be sure to cut unused lead wires at the bottom and insulate the ends. Français 4 4 - + Brown Red Orange Yellow Green Blue Purple Gray White ON • Terminal setting (2nd unit) Setting changes are only required when a 3rd unit is connected.
EFD.qxd 08.1.18 4:18 PM ページ 6 4 MOUNTING Mounting screws x 2 Back wiring 1-gang box English JF-2MED JF-2HD 83,5 mm (3-5/16") Peel off the protective film from the display surfaces of the JF-2MED and JF2HD. Français Mounting bracket 1. Press the RELEASE button (to insert or remove the wire). 2. Insert the cable into the terminal. 1 2 Nederlands 9mm (3/8") Surface wiring ∗ Cut open the cable inlet hole to run wires to the back of the unit.
EFD.qxd 08.1.18 4:18 PM ページ 7 6 OPERATING METHOD Main symbols and function descriptions To operate this unit, check the symbol and then press the appropriate operation button. This is not a touch-panel operation. Symbol Operation guidance display The guidance differs according to the screen. To play Message 1 for entrance. Symbol The symbols differ according to the screen. To play Message 2 for entrance. Operation buttons Press to select a symbol that is displayed on the screen.
EFD.qxd 08.1.18 4:18 PM ページ 8 7-3 SET THE DATE/TIME JF-2MED 1 After performing steps 1 and 2 in section 7-1, select "SET 3 Press CALL button to set the "Year" and move the cursor to "Month". THE DATE/TIME" and press CALL button. English 2006 01 JAN 00:00 2006 01 JAN 00 : 00 SELECT 2 In the time setting screen, press PLAY button or REC button to 4 Perform the same steps to set the "Month", "Day", "Hour" and "Minute". After setting "Minute", press CALL button to complete the settings.
EFD.qxd 08.1.18 4:18 PM ページ 9 7-7 SET DOOR2 JF-2MED 2 In the "SET DOOR2" screen, press PLAY button or REC button to When connecting door station 2, set "Video", "Audio" or "None (door station 2 not connected)". These operations must be performed by an installer. Please do not change these settings yourself. select the type of door station that is connected. 1 After performing steps 1 and 2 in section 7-1, select "SET DOOR2" and press CALL button.
EFD.qxd 08.1.18 4:18 PM ページ 10 8 OPERATIONS 8-1 Answering a door call (HANDS-FREE mode, PTT mode) 1 Press CALL button. English Instant voice call function 2 Even without answering, door area can be seen and heard with video and audio (for approx. 45 seconds). Inside sound is not heard outside. Français 2 Chime tone sounds, caller is seen on video monitor, and outside sound is heard. • Audio and video turns off after approx. 45 seconds in not answered. NOTES: Not available on JF-D audio door station.
EFD.qxd 08.1.18 4:18 PM ページ 11 8-3 Message for entrance 1 During communication, instant voice call or entrance 3 Press either CALL button or PLAY button. The selected Message changes to yellow, "SENDING MESSAGE" is displayed, and the selected message is played from door station. monitoring, press MENU/MEMO button to display the menu screen. THE TALK BUTTO N TO END. SEND MESSAGE FOR ENTRANCE 2 Press PLAY button.
EFD.qxd 08.1.18 4:18 PM ページ 12 8-6 Transfer entrance call English 1 During communication with door station, press CALL button to call 3 If TALK button is pressed at the transferred station, communication the transferring station. • CALL button (red) flashes and the communication with door station is put on hold. • The "All Call" function is activated to link all the master/sub stations. NOTES: 1.
EFD.qxd 08.1.18 4:18 PM ページ 13 8-9 Play recorded picture If there are automatically recorded pictures, such as those taken while you were out, the play LED (red) flashes. Displayed when picture is unread (not displayed after playing) Displayed when picture is saved (Refer to section 8-10) 3/16 2006 02 DEC 18 : 45 Sequence number of picture currently being displayed/total recorded pictures Time and date of recording 2 Press PLAY button on the play screen. The recorded picture is played.
EFD.qxd 08.1.18 4:18 PM ページ 14 8-11 Erase recorded picture It is also possible to erase saved recorded pictures. The erasure of recorded pictures is performed for each picture in turn. 2 Press REC button. 3/16 2006 02 DEC 18 : 45 English 1 Display the picture that you want to erase in the play screen. (Refer to section 8-9) Press MENU/MEMO button to display the save/erase selection screen. SAVE/ERASE 3 Press CALL button to erase.
EFD.qxd 08.1.18 4:18 PM ページ 15 8-14 Erasing Voice memos JF-2MED 1 Press MENU/MEMO button in the standby mode. 3 Press MENU/MEMO button. 02 DEC 18:45 02 DEC 18:47 02 DEC 18:48 2 Select the memo that you want to erase with CALL PLAY REC ERACE 4 Press CALL button to erase. Press PLAY button to stop the English SELECT erasure and return to the Voice memo selection screen. Once a Voice memo is erased, it cannot be restored. button.
EFD.qxd 08.1.18 4:18 PM ページ 44 WARRANTY This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
