Specifications

SET UP - Accessing Program Mode
7
Note:
• A maximum of 10 seconds are allowed for each programming input. If the time exceeds 10 seconds,
the GT-TLI returns to standby mode.
• No programming entries are possible when the GT-TLI is playing indicator sounds.
• Entering a correct function code is indicated by 1 long beep.
• Correct entry of parameters are indicated by the message “The code entered is correct”
(see Programming Summary Chart).
• Incorrect entry of parameters are indicated by 2 long beeps, or by the automated message
“The code entered is incorrect”. The GT-TLI will wait for a new function number.
Remote programming via DTMF telephone
• DialthetelephonenumberoftheGT-TLI(tenant’sphonenumber).
• Anautomatedmessagewillplay“Callfromdoorpanel.”
• Dialoneofthetwofollowingprogramaccesscodes;
⃰
2000# or
⃰
2001#.
⃰
2000#=generalparameters(volumelevels,timing,etc.)
⃰
2001#=controlledparameters(callingtelephone#,etc.)
• Anautomatedmessagewillplay“Thecodeenterediscorrect.”
• Makeprogrammingchanges(seenextpage).
• Whenprogrammingiscomplete,dial00toexit.
• “Thecodeenterediscorrect”willbeplayedandtheGT-TLIwillgointoidlemode.
Local programming via telephone connected directly to GT-TLI
• Flipthe3positionswitchontheGT-TLItoLOCAL PROG.
• Activate handset on connected telephone.
• Dialoneofthetwofollowingprogramaccesscodes;
⃰
2000# or
⃰
2001#.
⃰
2000#=generalparameters(volumelevels,timing,etc.)
⃰
2001#=controlledparameters(callingtelephone#,etc.)
• Anautomatedmessagewillplay“Thecodeenterediscorrect.”
• Makeprogrammingchanges(seenextpage).
• Whenprogrammingiscomplete,dial00toexit.
• “Thecodeenterediscorrect”willbeplayedandtheGT-TLIwillgointoidlemode.
• Hanguphandsetandreturnthe3positionswitchtoONposition.