Specifications

6 | GT-TLI Installation / Operation Instructions
SET UP
Linking GT-TLI to GT system (continued)
TheGT-TLIcanbeprogrammedeitherwiththelocal(internal)telephoneorremotelybycallingin,viaDTMF.
(seeowchartbelow)
EnterPassword
⃰
2000# or
⃰
2001#
Enter programming
• telephone #
• time outs
• audio levels
• etc...
Enter00toexit
programming
GT-DM Entrance Station Addressing
Step 1: Whileinstandbymode,enter#plusIDcode(defaultis
⃰
1111).Re-enterIDcode.
Step 2: Usetheup/downarrowsandscrollto
PROGRAMMING
. Push the Bell button to enter programming mode.
TheamberLEDwillbeginashing,thenremainlit.Oncelit,theentrypanelisinprogrammingmode.TheLCDwill
show“CONNECTING”whileinprogrammingmode.
Step 3: AtGT-TLI,pressthePROGbutton.TheGT-TLIisnowconnectedtotheentrancepanel.
Step 4: Scroll to the station number to be programmed or manually dial the number. When the tenant station number is
displayed,pushandreleasetheBell button to assign the address to the GT-TLI station that is active. A blip tone
willbeplayed.
Step 5: AtGT-TLI,pressthePROG button to complete programming.
Step 6: Toexitprogramming,pressthe“X”buttononthepaneltoreturntothemainmenu(theamberLEDwillturnoff).
Scroll to
QUIT
andpressthe“X”buttonagain.Thesystemisnowreadyforuse.
DO NOT press and hold the Call Button as doing so will clear the memory for this entry.
Select“LOCALPROG”
on GT-TLI
Pick up local telephone
and dial code
Local Telephone
Dial phone #
of GT-TLI
Remote Telephone