Specifications

10 | GT-TLI Installation / Operation Instructions
SET UP - Advanced Programming (continued)
Communication Level For Local Telephone
AdjustthereceiveandtransmitcommunicationvolumefortheGTentrancepaneltothelocallyconnectedtelephone.
Receive from GT Entrance Panel. The default setting = 04.
• Enter program access code
⃰
2000# -“Thecodeenterediscorrect”willbeplayed
• Enter 06-1longbeepwillbeplayed
• Enter nn(nn=level,00maxlevel-31minlevel)-“Thecodeenterediscorrect”willbeplayed
Transmit to GT Entrance Panel. The default setting = 10.
• Enter program access code
⃰
2000#-“Thecodeenterediscorrect”willbeplayed
• Enter 07-1longbeepwillbeplayed
• Enter nn(nn=level,00maxlevel-31minlevel)-“Thecodeenterediscorrect”willbeplayed
Communication Level for Remote Dialed Telephone
AdjustthereceiveandtransmitcommunicationvolumefortheGTentrancepaneltotheremotedialedtelephone.
Receive from GT Entrance Panel. The default setting = 04.
• Enter program access code
⃰
2000#-“Thecodeenterediscorrect”willbeplayed
• Enter 08-1longbeepwillbeplayed
• Enter nn(nn=level,00maxlevel-31minlevel)-“Thecodeenterediscorrect”willbeplayed
Transmit to GT Entrance Panel. The default setting = 10.
• Enter program access code
⃰
2000# -“Thecodeenterediscorrect”willbeplayed
• Enter 09-1longbeepwillbeplayed
• Enter nn(nn=level,00maxlevel-31minlevel)-“Thecodeenterediscorrect”willbeplayed
Time Setting for Delay Call Transfer
Setthedelaytimewhendelaycalltransferisenabled.Calltransfercanbedelayedfrom1-40seconds.
The default setting = 10.
• Enter program access code
⃰
2000# -“Thecodeenterediscorrect”willbeplayed
• Enter 64-1longbeepwillbeplayed
• Enter nn(nn=timeinsec.,01-40)-“Thecodeenterediscorrect”willbeplayed
Switching to Communication Mode with Remote Telephone
Choosebetween3waysofswitchingtocommunicationwiththeremotetelephone.
0=switchifendofringingtoneisdetected
1=switchifDTMFdetected
2=switchimmediately(default)
• Enter program access code
⃰
2000#-“Thecodeenterediscorrect”willbeplayed
• Enter 95-1longbeepwillbeplayed
• Enter n(n=mode,0-1-2)-“Thecodeenterediscorrect”willbeplayed