Specifications

Pg. 20
12.2 Adaptor Configuration via the program
Expand the General section to see the
MAC address for the IPW-1A adaptor.
You will also be able to assign the ID
number and Location Name for each
adaptor here. Show offline determines
whether the IPW-1A should remain in the
CommuniCenter intercom list, even if it
becomes disconnected or unreachable.
Expand the Network section to set the
network settings for each IPW-1A. You
can enable or disable different IP address
grabbing protocols, change the UDP port
the system uses, and enable SonicIP
which announces the IP address upon
“power on”.
Expand the Audio section to adjust the
quality (bandwidth settings) of the audio
as well as the speaker volume and
microphone gain, and to enable or disable
the pre-tone at the substation.
Expand the Relay Control section to set
the functionality of the relay and the
release duration of the relay. The release
duration will only be selectable if the relay
functionality is set to „Door Release‟.
Expand the Factory Defaults section if
the need arises to reset the IPW-1A
adaptor to factory default settings.
The relay function of the IPW-1A can also
be configured to release on talking,
release on connected, or release on
calling. Configuring the relay for any of
these functions will disable the “key” (door
release) option from the software for that
particular adaptor.