Specifications

12. Hardware Configuration
12.1 Accessing the hardware configuration from within CommuniCenter
o Right click the desired sub station in the Sub Station Location List. This will give you the
option to reset the IPW-1A, or access the settings via the program or through the browser.
o To reset the unit, click on Reset or press the R key. This will cause the sub station to
temporarily disappear from the Sub Station Location List. At the sub station, you will hear the
unit‟s IP address. Note: if the device is „In Use‟, the reset command will be ignored. Once reset,
the unit will once again appear in the Sub Station Location List.
o To access the settings via the program, click on Settings or press the S key. This will open the
Hardware Configuration Window and allow you to configure the IPW-1A.
o To access the settings via the web browser, click on Launch in browser or type the L key. This
will allow you to access the settings for the IPW-1A via the browser. You will also be able to
assign a password for the adaptor in the browser setting mode.
Pg. 19
Under Type are icons that indicate what each item is:
Blue square is for a Broadcast Mode intercom
Red circle is for another PC running CommuniCenter
Blue circle with symbol is for Direct Mode intercoms
Note: See page 23 A.2 for Direct Mode configuration.
11. Icon Descriptions
Under S.I. are icons showing the status of
each Sensor Input:
Sensor Input normal
Sensor Input closure detected