User Manual

8
5. Trouble Shooting
4.5 Installation of Foam Floating Blocks
Attention: If your robot is performing well, please ignore these
instructions.
The following illustration is limited to the use of white foam blocks to
increase coverage when the cleaning machine cannot completely clean
and cover the pool area.
Stick the two foams on the internal surface of the top cover (see the
picture below). Make sure the two foams are in the middle part of the
top cover.
Issues
The cable
twists or
coils up
The cable is not fully
released
Obstruction in the pool
Overtime working
Stuck on main drain outlet
Unplug the power cord
and fully release the cable
Remove the obstruction
Release the cable manually
Turn off the pool filter
system
Possible Causes Solutions
D. Close the cover and screw the fastener.
Remark: The pool water condition must be within the following
parameters:
• PH: 7.0 —7.8
• Temperature: 10°C(50°F) to 35°C(95°F)
• Salt: Max 5,000 ppm
• Chlorine: Max 2 ppm