Quick Guide

ManualsBrandsAina Wireless Finland ManualsElectronicsPTT over LTE and DMO

Google® is a registered trademark of Google Inc. Android™, Google

Maps™, Google Earth™, Google Play™, and Gmail™ are trademarks of

Google Inc.

BC-mark is registered trademark of California Energy Commission.

All brand and product names are trademarks, registered trademarks, or

service marks of their respecve holders.

The material contained herein is subject to U.S. export approval. No

export or re-export is permied without wrien approval from the U.S.

Government. Rated: EAR99 in accordance with U.S. Dept. of Commerce

regulaons 15CFR774, Export Administraon Regulaons.

Repairs to this equipment should be made only by an authorized service

technician or facility designated by the supplier. The opening of the

device’s back cover or any repairs, alteraons or substuon of parts

made to this equipment not approved by the manufacturer will void the

user’s authority to operate the equipment in addion to the

manufacturer’s warranty.

This product conforms to the European Union WEEE Direcve 2012/19/

EU. Do not dispose of this product in a public landll or open re. Take

it to a recycling center at the end of its life.

Hereby, AINA Wireless Finland Oy declares that the radio equipment

type AKEPLER-0001-00 is in compliance with Direcve 2014/53/EU.

The full text of the EU declaraon of conformity is available at the

following internet address: www.ainap.com/cercaons/

DECLARATION OF CONFORMITY

The following convenons are used throughout this manual to alert the

user to general safety precauons that must be observed during all

phases of operaon, service, and repair of this product. Failure to

comply with these precauons or with specic warning elsewhere in this

manual violates safety standards of design, manufacture, and intended

use of the product. AINA Wireless assumes no liability for the

customer’s failure to comply with these standards.

FCC Part 15

15.21

You are cauoned that changes or modicaons not expressly approved

by the part responsible for compliance could void the user’s authority to

operate the equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC rules. These limits

are designed to provide reasonable protecon against harmful

interference in a residenal installaon. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instrucons, may cause harmful interference to

radio communicaons. However, there is no guarantee that

interference will not occur in a parcular installaon. If this equipment

does cause harmful interference to radio or television recepon, which

can be determined by turning the equipment o and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

SAFETY CONVENTIONS

REGULATORY

• Reorient or relocate the receiving antenna.

• Increase the separaon between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Operaon is subject to the following two condions:

1. this device may not cause interference and

2. this device must accept any interference, including interference that

may cause undesired operaon of the device.

FCC RF Radiaon Exposure Statement:

This equipment complies with FCC radiaon exposure limits set forth for

an uncontrolled environment. End users must follow the specic

operang instrucons for sasfying RF exposure compliance. This

transmier must not be co-located or operang in conjuncon with any

other antenna or transmier.

Industry Canada

This device complies with Industry Canada license-exempt RSS

standard(s). Operaon is subject to the following two condions: (1) this

device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired

operaon of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio exempts de licence. L'exploitaon est

autorisée aux deux condions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout

brouillage radioélectrique subi, même si le brouillage est suscepble

d'en compromere le fonconnement.

European Union (EU) Waste of Electrical and Electronic Equipment

(WEEE) direcve.

The European Union’s WEEE direcve requires that products sold into

EU countries must have the crossed-out wheelie bin label on the

product (or the package in some cases). As dened by the WEEE

direcve, this crossed-out wheelie bin label means that customers and

end-users in EU countries should not dispose of electronic and electrical

equipment or accessories as household waste. Customers or end-users

in EU countries should contact their local equipment supplier or service

centre for informaon on the waste collecon system in their country.

WASTE (DISPOSAL) OF YOUR ELECTRONIC AND ELECTRIC EQUIPMENT

This manual is published by AINA Wireless Inc. without any warranty. Improvements

and changes to this manual necessitated by typographical errors, inaccuracies of

current informaon, or improvements to programs and/or equipment, may be made

by AINA Wireless Inc. at any me and without noce. Such changes will be

incorporated into new edions of this manual. No part of this manual may be

reproduced or transmied in any form or by any means, electronic or mechanical,

including photocopying and recording, for any purpose, without the express wrien

permission of AINA Wireless Inc.