Quick Guide

AINA Kepler
QUICK GUIDE
AINA Wireless
DOC ID : X ver. 1.2.
INCLUDED IN THE PACKAGE
X 1 X 1
BUTTONS AND CONNECTIONS
C. Emergency
K. Power
D. PTT 1
E. Speaker
F. PTT 2
G. Up arrow/
Volume up
H. Le arrow
A. Display
L. Headset jack
and micro-USB
charging
N. Right arrow
O. Down arrow/
Volume down
X 1
B. LED indicator
I. Belt clip
J. Microphone
M. Docking
staon charging
contacts
BUTTON FUNCTIONS
ICONS
Press unl the greed LED turns o to turn the device on or o.
While the device is o, pressing the buon will show the baery
level. When the device is on, it will open or close the devices
menu.
Press for 3 seconds to acve or cancel an emergency call.
During operaon, the up and down arrow buons are for volume
control.
While the device is on the menu screen, the up and down arrow
can be used for selecon.
During operaon, pressing the le or right arrow will change the
PTT1 group. Pressing the le or right arrow for 3 seconds will
change the PTT2 group.
While the device is on the menu screen, the le and right arrow
can be used for selecon.
Baery status. When there is an exclamaon mark (!) above the
icon, the baery is in crical level.
Network strength.
Connected to the service.
Disconnected from the service.
GPS posioning on.
Headphones connected.
CHARGING THE BATTERY
1 2
3 4
EN 1. Connect the provided USB cable to the device and wall charger.
2. The display will show the baery level for 10 seconds. 3. Wait
unl the device is fully charged. 4. Disconnect the USB cable.
NOTE! Recommended wall charger rang: 2A.
2
INSERTING THE SIM CARD
1 2
3 4
EN 1. Turn o the device and open baery cover with the provided
screwdriver and remove the devices baery. 2. Slide the SIM card
holder downward, li the holder into an upright posion and slide
the SIM card into the holder. Make sure the SIM cards gold
contacts will face into the device and the angled corner of the
card is posioned correctly (as shown in the picture above). Set
back down the SIM card holder and slide it upwards to secure it
(the SIM card should be lying at on the device). 3. Make sure the
inside of the device is clear of any dust and dirt, specially the grey
area shown above, to ensure the waterghtness of the device.
Angled corner

Summary of content (3 pages)