Datasheet

Series AMLDLW-Z
Up to 1000mA | LED Driver
www.aimtec.com Tel: [phone] Toll free: + 1 888 9 AIMTEC
(924 6832)
F 051e R9 2 of 11 North America only
General Specifications (continued)
Parameters Conditions Typical Maximum Units
Humidity 95 % RH
Case material Non-Conductive Black Plastic (UL94-V0 rated)
Weight 6.2 g
Dimensions (L x W x H) 0.92 x 0.55 x 0.40 inches 23.40 x 14.00 x 10.16 mm
MTBF > 500 000hrs (MIL-HDBK-217 F at +25
o
C)
Maximum Soldering Temperature 1.5mm from case for 10sec. 260
o
C
NOTES:
1.Reversed polarity at the input power will damage the driver. The input ground must not be connected to the negative output.
2.Leave the pin VADJ opened if not used , grounding VADJ will shut the driver off, connecting VADJ to +Vin will damage the driver.
3.Maximum output open voltage is equal to input voltage
Pin Out Specifications
Dimensions
Pin Single Description
1(Black) - V Input - DC Supply
2(White) Vadj PWM/ON/OFF or not used
8(Blue) -V Output LED Cathode Connection
9(Yellow) + V Output LED Anode connection
16 (Red) + V Output + DC Supply
19.60
(0.77)
14.00
(0.55)
11.00
(0.43)
23.40
(0.92)
2
8
16
1
9
Bottom View
10.16
(0.40)
14.00
(0.55)
100.00
(3.94)
10.00
(0.39)
12 16
10.16
(0.40)
14.00
(0.55)
100.00
(3.94)
10.00
(0.39)
89
All Wires are
Stripped & Tinned
Lead Wires are under the specifications of general lamps:
Wire is UL 1015/CSATEM listed #22AWG / 600V / 105ºC