Product Manual

14
(1) Shore/ Generator voltage (6) Output voltage
(2) DC voltage on inverter (7) Output frequency
(3) Load when inverting (8) Bypass/ inverter mode
(4) Low/high voltage, over temp,
overload
(9) Battery state of charge graph
(5) Fault condition
NOTE: The battery icon is just an image and does not
represent battery capacity. The bar graph will change
based on battery voltage (2). If using lithium, you may
see an instant drop on the graph.
A push button on the left side of the panel
can be used to turn off the LCD screen and
save 0.1A current draw on the battery.
1
2
3
4
5
6
7
8
9
LCD DISPLAY
WARNING
ONLY USE REMOTELF WITH PORT LABELED LCD. ONLY USE REMOTELFLED WITH PORT
LABELED LED. IF YOU PLUG INTO THE WRONG PORT, YOU CAN FRY THE INVERTER AND
NOT COVERED UNDER WARRANTY.
Never cut the remote cable when the cable is attached to inverter and battery is connected to the inverter. Even
if the inverter is turned off, it will damage the remote PCB inside if the cable is short circuited during cutting.