User's Manual

2 OPERATION
WARNING: Ensure the weapon is not loaded and the safety selector is in the
”safe” position before attempting to install, remove or perform maintenance.
2.1 Install battery
a Remove battery cap (1).
b Insert battery (2) with positive end (+) toward battery cap. See Fig 2.
CAUTION: Check that the O-ring is in good condition and in position to ensure
that there will be no water leakage into the battery compartment.
c Install battery cap. Hand tighten only. Using tools could damage the sight.
d Verify that the red dot is present by turning the rotary switch (7).
NOTE: Remove battery before putting the sight in storage for extended periods.
DL1/3N 2L76
Fig. 2 Install battery
2.2 Install Aimpoint
®
PRO on a weapon
a Select a groove on the Picatinny rail for a comfortable position in regards to
eye relief. Ensure the groove is undamaged and free from dirt and /or sand.
b Loosen the torque knob (13) of the QRP2 mount (12).
c Install the sight with the recoil stop in the selected groove of the Picatinny rail.
d Push the sight forward (toward muzzle) and tighten the torque knob (13) until
it snaps twice. This ensures that the mount is secured and the recoil stop is in
contact with the side of the groove of the Picatinny rail.