PRO™ User manual
1 PRESENTATION Aimpoint® red dot sights are designed for the ”two eyes open” method which greatly enhances situational awareness and target acquisition. The red dot follows the movement of the user’s eye while remaining fixed on target, eliminating any need for centering. Technical specification1.1.1 Optical system Optical magnification Eye relief 1X Unlimited Optical coating Anti-reflection (AR) coating Clear aperture 23 mm / 0.
Materials Sight Lens covers Hard anodized, high strength aluminum, black to dark gray, non-glare finish Thermoplastic elastomer, black, non-glare finish Environmental specification Temperature range (operation) -45 °C to +71 °C / -49 °F to +160 °F Temperature range (storage) -51 °C to +71 °C / -60 °F to +160 °F Water resistance 1 MOA: Minute Of Angle, 1 MOA ≈ 30 mm at 100 m or ≈ 1 in at 100 yds 2 NVD: Night Vision Device 3 Battery life: Values valid at room temperature for a quality battery 45 m / 14
1.2 Overview 11 3 1 2 4 5 8 9 6 4 3 7 10 16 12 13 15 14 Fig.
2 OPERATION WARNING: Ensure the weapon is not loaded and the safety selector is in the ”safe” position before attempting to install, remove or perform maintenance. 2.1 Install battery a Remove battery cap (1). b Insert battery (2) with positive end (+) toward battery cap. See Fig 2. CAUTION: Check that the O-ring is in good condition and in position to ensure that there will be no water leakage into the battery compartment. c Install battery cap. Hand tighten only. Using tools could damage the sight.
2.3 Zeroing CAUTION: Do not continue to adjust windage and elevation mechanisms if you encounter resistance. a Open front and rear lens cover (8) (9). b Turn the rotary switch (7) clockwise until the red dot has a sufficient intensity to contrast against the target. c Remove the windage and elevation adjustment caps (3). d Insert adjustment tool (coin, screwdriver, knife) or cartridge casing in adjustment screw slot.
3 OPERATION UNDER EXTREME CONDITIONS • Extreme heat (moist or dry). No special procedures required. • Extreme cold. Extreme cold might shorten battery life. • Salt air. No special procedures required. • Sea spray, water, mud and snow. Ensure that battery cap and adjustment caps are tightened before exposing the sight to sea spray, mud, snow or before immersing the sight in water. Hand tighten only. • Keep lens covers closed when sight is not being used.
Aimpoint AB Jägershillgatan 15 SE- 213 75 Malmö, Sweden Phone: +46 (0)40 671 50 20 Fax: +46 (0)40 21 92 38 e-mail: info@aimpoint.se WWW.AIMPOINT.COM © 2013, 2018 Aimpoint AB. [13648-3] Aimpoint Inc. 7309 Gateway Court Manassas, VA 20109, USA Phone: +1 703-263-9795 Fax: +1 703-263-9463 e-mail: info@aimpoint.
