User's Manual

2.2 Install Aimpoint
®
Micro T-2 on a weapon
If the sight is equipped with the mount shown in Fig. 1,
follow the described procedure. For installation with other
mounts, see accompanying instruction.
a Loosen the screw (14) using the tool (12 C), and clamp
the locking bar (13) around the Picatinny rail.
b With the screw (14) (recoil stop) positioned in a
groove of the Picatinny rail, push the sight forward
(towards muzzle) and tighten the screw (14) using the
tool (12 C)
c Tighten the screw (14) until a light resistance is
encountered. Proceed with another 1/4 to 1/2 turn until
fully tightened (2 Nm / 1.5 ft·lb).
CAUTION: Do not overtighten.
2.3 Zeroing
CAUTION: Do not continue to adjust windage and
elevation screws (3) and (4) if you encounter resistance.
a Open lens covers (10) and (11).
b Adjust the intensity (7) to a comfortable setting for the
red dot to contrast against the target.
c Remove the adjustment cap (1) and the cap (2) to
access the windage adjustment screw (4) and the
elevation adjustment screw (3). See Fig. 2.