User's Manual

The sight is impossible to zero
If an adjustment screw (3) or (4) is at its limit, check
the alignment of mount and barrel. If point of impact is
moving, check the stability of mount and weapon rail (or
carry handle)
The front lens of the sight is tilted, has the
sight been damaged?
No. The optical system is designed for the front lens to be
mounted in this way.
5 MOUNT INSTALLATION
To avoid damage to the sight and for proper assembly of
the base (8) onto the sight, the original screws (9) (M3, 4
pcs) must be tightened by hand and with the tool (12 C).
a
CAUTION: Do not use thread locking uid as it may
damage the thread inserts of the sight.
a Place the sight upside down in your hand.
b Press the base (8) against the sight and verify there is
no gap.
c Tighten the screws (9) in a crosswise pattern. Tighten
until resistance is encountered. Proceed with another
1/4 to 1/2 turn until fully tightened (1.35 Nm / 1.0 ft·lb).
CAUTION: Do not overtighten.