User's Manual

2 OPERATION

WARNING: Ensure the weapon is not loaded and the

safety selector is in the ”safe” position before attempting

to install, remove or perform maintenance.

2.1 Install battery

a Remove battery cap (6) using the tool (13B).

b Insert battery (7) with the positive end (+) toward battery

cap (6) as can be seen in Fig 3.

CAUTION: Check that the O-ring is in good condition

and in position to ensure that there will be no water

leakage into the battery compartment.

c Turn to the rotary switch (8) to intensity setting 12 (max.)

and tighten the battery cap (6) with the tool (13B). When

resistance is encountered, proceed to tighten until the

battery cap (6) comes to a stop.

d Verify that the red dot is present and that there is

zero gap between the battery cap (6) and the battery

compartment. See Fig. 1.

NOTE: Remove battery before putting the sight in

storage for extended periods.