User's Manual
10
5 MOUNT INSTALLATION
To avoid damage to the sight (1) and for the proper
assembly of the base (9) onto the sight (1), tighten the
original screws (M3x4) by hand and with the tool (13C).
CAUTION: Do not use thread locking uid as it may
damage the thread inserts of the sight (1).
a Place the sight (1) upside down in your hand.
b Press the base (9) against the Sight (1) and verify that
there is zero gap.
c Install the Screws (10) in a crosswise pattern. Tighten
each screw until a resistance is encountered. Proceed with
another 1/4 turn until fully tightened (1.35 Nm / 1.0 ft·lb).
CAUTION: Do not overtighten.