User's Manual

2.2 Install Aimpoint
®
Micro T-1 on a weapon
If the sight is equipped with the mount shown in Fig. 1,
follow the described procedure. For installation with other
mounts, see accompanying instruction.
a Loosen the screw (12) using the tool (10 C), and clamp
the locking bar (11) around the Picatinny rail.
b With the screw (12) (recoil stop) positioned in a
groove of the Picatinny rail, push the sight forward
(towards muzzle) and tighten the screw (12) using the
tool (10 C)
c Tighten the screw (12) until a light resistance is
encountered. Proceed with another 1/4 to 1/2 turn until
fully tightened (2 Nm / 1.5 ft·lb).
CAUTION: Do not overtighten.
d Proceed with zeroing (see 2.3)
2.3 Zeroing
CAUTION: Do not continue to adjust windage and
elevation screws (2) and (3) if you encounter resistance.
a Remove the bikini lens cover (9).
b Adjust the intensity (6) to a comfortable intensity setting
for the red dot to contrast against the target.
c Remove the adjustment caps (1) to access the windage
adjustment screw (3) and the elevation adjustment
screw (2). See Fig. 2.