User's Manual

2 OPERATION
WARNING: Ensure the weapon is not loaded and the
safety selector is in the ”safe” position before attempting
to install, remove or perform maintenance.
NOTE: To reach maximum protection for all weather
conditions, wax is added into the rubber mixture for the
bikini lens covers. For long time storage, the wax can
be seen as a grey lm on the surface of the part. To
restore to its original condition, please hand wash in
warm dishwater.
2.1 Install battery
a Remove the battery cap (4) using the tool (10 B).
b Insert battery (5) with positive end (+) toward battery
cap (4) as can be seen in Fig. 1.
CAUTION: Check that the o-ring is in good condition
and in position to ensure there is no water leakage into
the battery compartment.
c Turn to the intensity switch (6) to intensity setting 12
(max.) and tighten the battery cap (4) with the Tool
(10 B). When resistance is encountered, proceed to
tighten until the battery cap (4) comes to a stop.
d Verify that the red dot is visible and that there is zero
gap between the battery cap (4) and the battery
compartment.
NOTE: For storage of the sight, remove the battery.