User's Manual

The sight is impossible to zero
If an adjustment screw is at its limit, check the alignment
of mount and barrel. If point of impact is moving, check the
stability of mount and weapon rail (or carry handle)
The front lens of the sight is tilted, has the
sight been damaged?
No. The optical system is designed for the front lens to be
mounted in this way.
5 MOUNT INSTALLATION
To avoid damage to the sight and for proper assembly of
the base (7) onto the sight, the original screws (8) (M3, 4
pcs) must be tightened by hand and with the tool (10 C).
a Place the sight upside down in your hand.
b Press the base (7) against the sight and verify there is
no gap.
c Apply thread locking uid to the threads.
d Tighten the screws (8) in a crosswise pattern. Tighten
each screw until a slight resistance is encountered.
Proceed with another 1/4 turn until fully tightened. This
is equivalent to 0.8 Nm (0.6 ft·lb) of torque.
CAUTION: Do not overtighten.