User's Manual

Presentation
This Aimpoint Mount Kit mount is designed to
mount an Aimpoint Micro red dot sight on a Glock
pistol. This mount replaces the rear sight on the
Glock slide. An Aimpoint Micro red dot sight is not
included in this kit.
Physical Specifications
(The Micro Sight excluded)
Dimensions
Length: 60 mm (2.36”)
Width: 18 mm (0.71“)
Height: 6 mm (0.24”)
Weight (incl. screws): 35 grams (1.2 oz)
Material – Mount: High strength steel / Rubber
Material – Screws: Steel / Brass
Color: Matte black finish
Hazardous Materials: None
C) Remove the existing rear sight of the Glock pistol
by driving it (from side to side) completely out of the
dovetail slot in the pistol slide using a sight pusher,
or a non-marking drift and a small hammer. Use care
to avoid damaging the sight or the pistol slide.
Caution: If the sight supplied with your Glock
pistol contains luminescent night sight inserts, use
caution not to damage the sight while removing it.
Breaking the night sight inserts can expose you to
hazardous materials!
D) Insert the dovetail interface on the mount bracket
(#1) into the sight slot on the pistol slide (from one
side to the other), and move the mount bracket
sideways until the mount is centered on the pistol
slide.
E) Firmly tighten the set screw (#2) using the Allen
wrench supplied (#5).
Caution: Failure to securely fasten the mount to
the slide can result in the sight separating from the
pistol during operation which could result in serious
injury to the user!
Instructions for use
CAUTION! ENSURE THAT YOUR PISTOL IS
UNLOADED BEFORE PROCEEDING!
Wear safety glasses while performing this instal-
lation to protect your eyes. Read the instructions
below carefully, and if you are unsure of your ability
to safely follow any of these directions, STOP and
bring your pistol and mount to a qualified gunsmith
or Glock Armorer for assistance. Do not attempt to
utilize this mounting kit on any pistol other than a
Glock pistol with an original Glock manufactured
slide. Do not attempt to use this mounting kit with
any sight other than an original Aimpoint Micro sight
purchased from an authorized Aimpoint Dealer!
A) Following directions in the User’s Manual
supplied with your Glock pistol, carefully remove the
slide from the pistol, then remove the recoil spring
and barrel from the slide.
B) Fasten the Aimpoint Micro sight to the mount
bracket (#1) with four screws (#3), max torque
0,9 Nm (0,664 lbf ft), using the Torx head bit on
tool (#4).