User's Manual
Mounting CompM4™ / CompM4s™ with LRP mount:
1 Lift the lever (2) up to release it and set to open.
2 Position the recoil stop (3) in a groove to be used on the rail and install
the mount. See Fig. 1.
CAUTION: Ensure that the groove to be used is clean and free from dirt.
3 With the recoil stop (3) positioned in a groove of the rail, push the sight
with mount forward (toward muzzle) and close the lever (2) with the hand
(no tools) until it clicks into the slot of the base. See Fig. 2.
CAUTION: The lever (2) must never be forced to close by the use of pliers
or any other tool.
4 If the lever (2) cannot be closed or the mount does not clamp with
sucient force: set the lever (2) to open and tighten or loosen the
adjustment nut (1) before attempting to close the lever (2).
Fig. 1 Fig. 2
CAUTION: If the locking lever
is closed, the adjustment nut must
never be tightened! This can cause
the mount to break.