Manual

2.2.3. Adjustment of the Laser beam:
The laser can be adjusted horizontally and vertically.
Horizontal adjustment using the side located adjustment screws (3).
Vertical adjustment using the adjustment screws located on top (2).
To correct the point of impact, proceed as follows:
• Turning the side adjustment screw in the “+” direction moves the point of
impact to the right.
• Turning the side adjustment screw in the “-” direction moves the point of
impact to the left.
• Turning the top adjustment screw in the “+” direction moves the point of
impact down.
• Turning the top adjustment screw in the “-” direction moves the point of
impact up.
One click equals approx. 3 cm at 100 m
MAINTENANCE
The LPI requires no routine maintenance. When the lenses are soiled by dirt
or gun powder residue, a soft optical cloth is required to wipe the lens clean
If required, the reection shields can be removed (7).
Safety notice:
LASER beams can cause damage to the human eye. Target lasers are for
use by trained personnel only. The user is responsible to maintain the safety
precautions dened by local laws.
The use of this equipment is the sole responsibility of the operator.
User’s Manual for
AIMPOINT LPI
IR aiming laser device
Aimpoint AB
Jägershillgatan 15
SE- 213 75 Malmö, Sweden
Phone [phone]
Fax [phone]
e-mail: [e-mail]
www.aimpoint.com
Aimpoint Inc.
14103 Mariah Court
Chantilly, VA 20151-2113, USA
Phone [phone]
Fax [phone]
e-mail: [e-mail]
www.aimpoint.com
© 2008 - Contents property of Aimpoint - All rights reserved. [11536-1]
2.1.2. Installing remote switch pad trigger
Screw Trigger in to the side connector of the laser unit (5).
Attach Trigger pad to weapon using the Velcro lock. Usual positions are on
the pistol handle or over the thermal cover of the barrel using the supporting
hand for activation.
2.1.3 Installing the battery
Open battery cover (6). Insert battery in the correct direction in the same way
as you t the battery in the red dot sight. Make sure that the battery contacts
are clean. Close battery cover.
2.2 OPERATING PROCEDURES
2.2.1. Selecting a laser:
Turn the selector (4) to the desired position. The laser beam will only be
activated once you press the switch pad.
Left Position: Laser OFF
Position 1: The Laser is at low power.
Position 2: The Laser is at high power.
2.2.2. Switch pad trigger activation:
The laser must be on position 1 or 2.
Pressing the Trigger switch activates the Laser.
When the switch is released, the laser is interrupted.