User's Manual

4 TROUBLESHOOTING
The red dot does not appear or has disappeared
Make sure contact surfaces in the battery compartment
are clean and verify that a working battery (2) is installed
correctly according to 2.1. If the intensity switch (5) is
defective, notify local dealer/armourer.
The sight is impossible to zero
If an adjustment screw (8) or (9) is at its limit, check
the alignment of mount and barrel. If point of impact is
moving, check the stability of mount and weapon rail (or
carry handle)
5 INSTALLATION INSTRUCTIONS
To avoid damage to the sight and for the proper assembly of
the base (10) onto the sight, the original screws (13) (M3,4 pcs)
must be tightened by hand and with the tool (14 C).
a Place the sight upside down in your hand.
b Press the base (10) against the sight and verify there
is no gap.
c Apply thread locking uid to the threads and install the
screws (13).
d Tighten the screws (13) in a crosswise pattern. Tighten
until resistance is encountered. Proceed with another
1/4 to 1/2 turn until fully tightened (1.35 Nm / 1.0 ft·lb).
CAUTION: Do not overtighten.