User's Manual

4 TROUBLESHOOTING
The red dot does not appear or has disappeared
Make sure contact surfaces in the battery compartment
are clean and verify that a working battery is installed
correctly according to 2.1. Ensure that the battery cap is
rmly tightened. If the intensity switch is defective, notify
local dealer/armourer.
The sight is impossible to zero
If an adjustment screw is at its limit, check the alignment
of mount and barrel. If point of impact is moving, check the
stability of mount and weapon rail (or carry handle)
5 INSTALLATION INSTRUCTIONS
To avoid damage to the sight and for the proper assembly
of the base (9) onto the sight, the original screws (12) (M3,
4 pcs) must be tightened by hand and with the tool (13 C).
a Place the sight upside down in your hand.
b Press the base (9) against the sight and verify there is
no gap.
c Apply thread locking uid to the threads and install the
screws (12).
d Tighten the screws (12) in a crosswise pattern. Tighten
until resistance is encountered. Proceed with another
1/4 to 1/2 turn until fully tightened (1.35 Nm / 1.0 ft·lb).
CAUTION: Do not overtighten.