CompM4s™ with QRP2 mount, spacer and ARD User manual
1 PRESENTATION Aimpoint red dot sights are designed for the ”two eyes open” method of sighting, which greatly enhances situational awareness and target acquisition. The red dot follows the movement of the user’s eye while remaining fixed on the target, eliminating the need for centering. Further, the sight allows for unlimited eye-relief and is compatible with 1st , 2nd and 3rd generation night vision devices (NVD). 1.
1.2 Location and description of major components Fig. 1 1. 2. 3. 4. 5. 6. 7. 8. 9. Adjustment cap (2 pcs) Strap (for adjustment cap) (2 pcs) Battery (AA size) Battery cap Strap (for battery cap) Screws (for Mount) (2 pcs) Screws (for Mount with spacer) (2 pcs) QRP2 mount Spacer 10. Rotary switch 11. Adjustment screw (2 pcs) 12. Torque knob (QRP2 mount) 13. Lens covers (Bikini) 14. Allen wrench for screws (pos.6 and 7) 15.
2 OPERATION UNDER NORMAL CONDITIONS WARNING: Ensure the weapon is not loaded and the safety selector is in the ”safe” position before attempting to install, remove or perform maintenance. 2.1 Install Battery 2 T t w s t 1 Remove battery cap (4) by turning it counter clockwise. 2 Insert an AA-size battery (3) with negative (-) end toward battery cap (4). CAUTION: Check that the o-ring is in good condition and in position to ensure that there is no water leakage into the battery compartment.
2.4 Zeroing The sight is delivered with the red dot in a centered position. Normally this means that only small adjustments are necessary, providing that the weapon rail or carrying handle is properly aligned. The elevation adjustment screw is located on top of the sight, while the windage screw is located on the right side. CAUTION: Do not continue to adjust windage and elevation mechanisms if you encounter resistance. 1 Remove the lens cover (13).
3 OPERATION UNDER EXTREME CONDITIONS • Extreme heat (moist or dry): No special procedures required. • Extreme cold: Extreme cold might shorten battery life. • Salt air: No special procedures required. • Sea spray, water, mud and snow: Ensure that battery cap (4) and the two adjustment caps (1) are tightened before exposing the sight to sea spray, mud, snow or before immersing the sight in water. Hand tighten only. Keep lens covers closed when sight is not being used.
4 TROUBLE SHOOTING PROCEDURES 4.1 The red dot does not appear Discharged battery: Battery installed incorrectly: Replace battery. Remove and reinstall battery with (-) toward battery cap. Battery is not making contact: Clean contact surfaces and reinstall battery. Defective Rotary switch: Notify dealer/armourer. 4.2 Impossible to zero Adjustment screw is at its limit: Check alignment of rail (or carry handle) Impact point is moving: Check Mount and weapon rail (or carry handle) stability.
Aimpoint AB Jägershillgatan 15 SE- 213 75 Malmö, Sweden Phone: +46 (0)40 671 50 20 Fax: +46 (0)40 21 92 38 e-mail: info@aimpoint.se WWW.AIMPOINT.COM © 2012, 2017 Aimpoint AB. [12171-2] Aimpoint Inc. 7309 Gateway Court Manassas, VA 20109, USA Phone: +1 703-263-9795 Fax: +1 703-263-9463 e-mail: info@aimpoint.
