User's Manual
2.4 Zeroing
The Sight is delivered in a centered position. Normally this means that only
small adjustments are necessary, providing that the weapon rail or carrying
handle is properly aligned. The elevation adjustment screw is located on top
of the sight, while the windage screw is located on the right side.
CAUTION: Do not continue to adjust windage and elevation mechanisms
if you encounter resistance.
a Remove the Lens Cover (8).
b Turn the Rotary Switch (7) clockwise until the red dot has a sucient
intensity to contrast against the target.
c Remove both Adjustment Caps (1).
NOTE: Each click of the Adjustment Screws (6) corresponds to a 16 mm
movement of the point of impact at 100 meters, (4 mm at 25 meters and 32
mm at 200 meters or 1⁄2” at 80 yds).
d Insert adjustment tool (coin, screwdriver, knife) or cartridge casing in
adjustment screw slot and turn as follows:
• To move the point of impact to the right, turn windage adjustment
screw counter clockwise .
• To move the point of impact to the left, turn windage adjustment screw
clockwise.
• To move the point of impact up, turn elevation adjustment screw
counter clockwise.
• To move the point of impact down, turn elevation adjustment screw
clockwise.
e Conrm zeroing by ring at least three shots at a zeroing target. Check
points of impact on zeroing target to conrm accuracy and repeat above
procedure if required.
f After initial ring, ensure that the Mount and Sight are secure.