Manual

6
• To move the point of impact up, turn elevation adjustment screw
counterclockwise.
• To move the point of impact down, turn elevation adjustment screw
clockwise.
e) Confirm zeroing by firing at least three shots at a zeroing target.
Check impact points on zeroing target to confirm accuracy and
repeat above procedure if required.
f) After initial firing, ensure that the mount and sight are secure.
g) Turn rotary switch to OFF position (counterclockwise).
h) Close front and rear lens covers.
CHAPTER III
OPERATION UNDER EXTREME CONDITIONS
a) Extreme heat (moist or dry). No special procedures required.
b) Extreme cold. Extreme cold might shorten battery life. Keep spare
batteries in your inner pockets to keep them warm.
c) Salt air. No special procedures required.
d) Sea spray, water, mud and snow. Ensure that battery cap and two
adjustment screw caps are tight before exposing the sight to sea
spray, mud, snow or before immersing the sight in water. Hand
tighten only. Keep lens covers closed when sight is not being used.
Clean lenses with lens paper/cloth and wipe the sight dry as soon as
possible after exposure to water, sea spray, mud or snow.
e) Dust storms and sand storms. Keep lens caps closed when sight is
not being used.
f) High altitudes. No special procedures required.
CAUTION: The lenses shall never be cleaned with fingers but with lens
paper/cloth. If no lens paper/cloth available :
- To clear away debris (sand, grass etc): blow away the dirt.
- To clean lenses: mist up the lenses and dry them with a clean and soft
piece of cloth.