Manual

4
CHAPTER II
OPERATION UNDER NORMAL CONDITIONS
2.1. ASSEMBLY AND PREPARATION FOR USE
WARNING: Insure the weapon is unloaded and the safety selector is in
the ”safe” position before attempting to install, remove or perform
maintenance on the sight.
2.1.1. Installing Battery
a) Remove battery cap by turning it counterclockwise.
b) Insert battery with positive (+) end toward cap.
Caution while replacing battery (not necessary when the sight is unused)
Before installing battery cap, inspect that the O-ring is present and not
damaged. Failure to do so could result in water leakage into the battery
compartment.
c) Install battery cap by turning clockwise until snug. Hand tighten
only. Using tools could damage equipment.
d) Verify that red dot is present by turning the rotary switch clockwise.
2.1.2. Installing Ring and Sight on the weapon
Aimpoint’s sights are designed for installation on most types of
weapons. If your weapon does not have or support an appropriate
base(s), please consult your dealer, gunsmith or other qualified source.
a) Assemble the sight to the weapon by using Aimpoint´s wide 30 mm
ring or QR-mount. If other standard 30 mm rings are used, make
sure that the ring(s) covers a length of minimum 25 mm or 1” (two
standard rings could possibly be used).
b) Ensure that the sight is correctly positioned for right or left hand
shooting, see fig 2 and 3.
c) When using lens covers, ensure that they are correctly positioned
and can be opened.