User's Manual

2 OPERATION

WARNING: Ensure the weapon is not loaded and the safety selector is in the

”safe” position before attempting to install, remove or perform maintenance.

2.1 Installing Battery

a Remove battery cap (2) by turning it counterclockwise.

b Insert battery (3) with positive end (+) toward battery cap (2). See Fig 2.

CAUTION: Check that the O-ring is in good condition and in position to ensure

that there will be no water leakage into the battery compartment.

c Install battery cap (2) by turning clockwise until snug. Hand tighten only. Using

tools could damage the equipment.

d Verify that the red dot is present by turning the rotary switch (4).

NOTE: Remove battery before putting the sight in storage for extended

periods.

2.2 Installing Ring and Sight on the weapon

Aimpoint

sights are designed for installation on most types of weapons. For

mounting, certain models come with one or two rings, for other models, use

standard rings available on the market. If your weapon does not have or support

an appropriate base(s), please consult your dealer, gunsmith or other qualied

source.

• When using two separate bases on the weapon, ensure that the bases are

parallel and aligned.

• Assemble the ring(s) on the appropriate weapon base (a Weaver or Picatinny

base). When using 2 rings, make sure that the distance between the rings is

appropriate to the sight.

NOTE: Make sure that you have space between the bottom front part of the

sight and the top of the base/weapon.

• For Comp models: Assemble the sight to the weapon by using Aimpoint´s wide

30 mm ring or QR-mount. If other standard 30 mm rings are used, make sure

that the ring(s) covers a length of minimum 25 mm or 1 in (two standard rings

can be used).

• For 9000 models: Assemble the sight to the weapon with any standard

30mm rings.

• Ensure that the sight is correctly positioned for right-handed (Fig. 6) or left-