User's Manual
7
3 OPERATION UNDER EXTREME CONDITIONS
• Extreme heat (moist or dry). No special procedures required.
• Extreme cold. Extreme cold might shorten battery life.
• Salt air. No special procedures required.
• Sea spray, water, mud and snow. Ensure that battery cap and two adjustment
screw caps are tight before exposing the sight to sea spray, mud, snow or
before immersing the sight in water. Hand tighten only.
• Keep lens covers closed when sight is not being used. Clean lenses with lens
paper/cloth and wipe the sight dry as soon as possible after exposure to water,
sea spray, mud or snow.
• Dust storms and sand storms. Keep lens caps closed when sight is not being
used.
• High altitudes. No special procedures required.
CAUTION: The lenses shall never be cleaned with ngers but with lens paper/cloth.
If no lens paper/cloth available:
• To clear away debris (sand, grass etc): blow away the dirt or rinse with
clear water.
• To clean lenses: mist up the lenses or rinse with clear water and clean them
with a soft piece of cloth.
4 TROUBLE SHOOTING
4.1 The red dot does not appear or has disappeared
Clean contact surfaces in the battery compartment and verify that the battery (3)
is working and that it is installed correctly. Verify that there is zero gap between
the battery cap (2) and the battery compartment.
4.2 The sight is impossible to zero
If an adjustment screw (7) is at its limit, check the alignment of mount and barrel.
If point of impact is moving, check the stability of mount.
4.3 The red dot does not appear to be round
Most likely the result of how your eye perceives the red dot. Unload and make
your rearm safe. Turn on the sight, look at the red dot and slowly rotate the
sight. If the aberration in the shape of the red dot does not rotate along with the
sight, the irregularity is caused by how your eyes percieves the red dot. Minimize
this eect by always setting the intensity of the red dot to the lowest setting where
the red dot is clearly visible against the target in relation to ambient light.