User's Manual

handed shooters (Fig. 7). To mount the rubber cover (11) on the CompM3 and

CompML3, you must position the sight as shown in Fig. 6.

• When using lens covers, ensure that they are correctly positioned and can be

opened.

• Finally, make sure that all screws are rmly tightened.

2.3 Installing the Rubber Cover on CompM3 and ML3

NOTE: The rubber cover shall be mounted to the CompM3 and ML3 after the

sight has been installed in the ring.

See Fig. 5.

a Remove front and rear lens cover (9) and (10).

b Put the front part of the sight into the lower opening of the rubber cover (11) and

pull the cover backwards over the rear part of the sight. Be careful not to pull too

hard to avoid damaging the rubber cover.

c Reinstall the lens covers (9) and (10).

d When removing the rubber cover (11) from the sight, do the opposite way.

Start to pull o the rear part of the sight by gripping the lower rear part of the

rubber cover, pulling the rubber backwards and upwards.

NOTE: To reach maximum protection level for all weather conditions, wax is added

into the rubber mixture. The wax will slowly migrate to the surface of the part.

During frequent use this wax will be used up completely and not noticed by the

user. For long time storage, the wax will not be used up as frequently and will

be seen as a grey lm on the surface. To restore to its original condition, please

hand wash in warm dishwater.