User's Manual

2.2 Turn ON / OFF and adjust red dot intensity
• Press or to turn the sight ON.
NOTE: The sight will always turn ON at setting 7 of 10.
• Hold to turn the sight OFF.
• Press or to adjust red dot intensity.
NOTE: Intensity setting 1-2 are intended for use with
NVD and intensity setting 3 - 10 for use in daylight.
2.3 Install the sight
To install the sight to an interface compatible with the

procedure:
a 

dovetail interface.
b 
the sight forward (toward muzzle) and tighten the
screw (5).
c Tighten the screw (5) until a light resistance is
encountered. Proceed with another 1/4 to 1/2 turn until
fully tightened (3 Nm / 2.2 ft·lb).
d 
sight is securely fastened.
CAUTION: Do not overtighten.