3X-C™ Magnifier User manual
1 PRESENTATION The Aimpoint® 3X-C Magnifying module can be used in conjunction with all Aimpoint sights for long-range aiming or observing. A variable (-2 to +2) dioptric setting allows this magnifier to be adapted to the individual shooter’s eye. The Aimpoint 3X-C can also be used as a handheld 3X monocular. Aimpoint magnifiers utilize the red dot in Aimpoint sights as the aiming reticle, eliminating the need for re-zeroing when shifting between non-magnified and magnified aiming.
1.2 Technical specifications Optical system Magnification Exit pupil diameter Field Of View (FOV) Diopter adjustment range Eye relief Photopic, integral transmission 3X 6.5 mm 6° ± 2.0D 56 mm 75 % Physical specification Material housing Dimensions (L × W × H): Weight Anodized black aluminum, black rubber cover 103 mm × 45 mm × 45 mm (4” × 1 ¾” × 1 ¾”) 220 g (7.
2 OPERATION WARNING: Ensure the weapon is not loaded and the safety selector is in the ”safe” position before attempting to install, remove or perform maintenance on the 3X-C - other than attaching/detaching it under normal use. 2.1 Installing the Aimpoint® 3X-C on a weapon The mounting surface (3) of the 3X-C allow for mounting to any 30 mm diameter ring mount. Follow the manufacturer’s instructions when installing the 3X-C.
The height of the mount is correct when the optical axis of the 3X-C and the Aimpoint sight coincide. Select a suitable position for the 3X-C on the weapon base so the eye relief is correct and feels comfortable. Assemble the 3X-C to the chosen mount and install it on the weapon. The 3X-C shall be mounted with the Aimpoint logo to the left. Carefully tighten the mount to the weapon base and retighten after a few rounds. NOTE: Any adjustments (see “2.
2.2 Centering The 3X-C does not need to be zeroed. However, an Aimpoint sight used together with the 3X-C must be zeroed so the red dot of the sight creates the correct point of impact. The 3X-C has two screws (1) that allow the user to center the red dot of the Aimpoint sight when viewed through the 3X-C. Centering the dot inside the 3X-C is not necessary, but creates a more natural feel. CAUTION: Do not continue to adjust the screws if you encounter resistance. 1 Fig. 5 Centering 1.
3 EXTREME CONDITIONS Use in extreme heat or cold, salt air, sea spray, water, mud and snow, dust and sand storms or high altitudes does not require any special procedures. 4 MAINTENANCE To reach maximum protection level for all weather conditions, wax is added into the rubber mixture. The wax is slowly migrating to the surface of the part. The wax is used up completely during frequent use and is not noticed by the user.
Aimpoint AB Jägershillgatan 15 SE- 213 75 Malmö, Sweden Phone +46 (0)40 671 50 20 Fax +46 (0)40 21 92 38 e-mail info@aimpoint.se WWW.AIMPOINT.COM © 2016 Aimpoint AB. [14607-1] Aimpoint Inc. 14103 Mariah Court Chantilly, VA 20151-2113, USA Phone +1 703-263-9795 Fax +1 703-263-9463 e-mail info@aimpoint.
