User guide

LCU-ONE Analog

User Manual

Release 1.02

Chapter 3 – Configuration

To work properly LCU-ONE Analog needs to be configured. The configuration can be

made both using Race Studio 2 and using Lambda Configurator the free software -

included in the kit - properly designed and developed by AIM to configure this device.

3.1 – LCU-ONE Analog standard configuration

Configuration through Race Studio 2 (standard) is possible only if calibration curve

default points – 1.95=0.65 and 4.8=1.6 – have not been modified.

To configure LCU-ONE Analog with Race Studio Configuration follow this procedure:

• run the software;

• press “AIM system manager” button on the left vertical keyboard;

• select the logger LCU-ONE Analog is connected to

• activate “Channels” layer

• select the analogue channel to set the probe on

• double click on “Sensor type” column corresponding to that channel and

select “AIM Lambda LCU-ONE 1.65 – 1.6 Lambda)” option as shown here

below; click out of the cell to confirm the choice.