Brochure

The PSA Series II can be used vertically, as well
as horizontally or on its tilt stand.
The PSA Series II will find plenty of ap-
plications on the bench as well as in the
field.
It’s low cost enables every engineer
to have access to a spectrum analyzer
whenever they need one.
For continuous bench-top operation,
the supplied AC line adaptor powers the
instrument as well as charging it.
The rigid tilt stand angles the instrument
at about 40 degrees to the horizontal.
Equally at home on the bench
True portability
A genuinely hand-held instrument
Some manufacturers have stretched the term hand-
held to cover any battery powered instrument with
a ‘flat’ format.
Some of these are more than twice the width
of an average hand, and weigh as much as a
brick. Not so the PSA Series II.
The small size fits perfectly into the hand and
the low weight of only 560 grms (20 oz)
allows it to be carried anywhere.
Instant availability
Unlike some other spectrum analyzers
which can take up to a minute to
initialise, the PSA Series II starts
instantly, with the first sweep
available in less than two
seconds from switching on.
Typical ‘hand-held’ spectrum
analyzer 26 cm x 17 cm,
weight >2kg
PSA Series II 19 cm x 9.2 cm,
weight < 0.6kg
Around one third of the size
and one quarter of the weight !
Screen Protector and Sun Shield
When on the move and operating out of doors, the tilt stand can be un-
clipped from the back of the instrument and attached at the front.
This protects the screen during transport, and can act as a sun shield when
viewing conditions are difficult.
When no longer required it can be re-attached to the rear where it stows
out of the way until needed.