Instructions

Seite 54
Frequency
Range
Accuracy
Resolution
100Hz
0.01Hz
1000Hz
0.01% ± 1 dig.
0.1Hz
10kHz
1Hz
100kHz
10Hz
Accuracy specifications for 100Hz range apply only at slow measurement speed of 4 readings
per second.
Range:
10Hz to 100kHz
Input sensitivity:
Better than 30mVrms (100mV range); better than 10% of range for
all other Vac and Iac ranges.
Capacitance
Scale length: 1200 counts
Range
Accuracy
Resolution
10nF
10pF
100nF
2% ± 5 dig.
100pF
1uF
1nF
10uF
10nF
100uF
5% ± 5 dig.
100nF
Temperature
Linearised measurement for PT100 or PT1000 RTD probes, 2-wire or 4-wire measurement
display in ºC or ºF.
RTD
Range
Accuracy
Resolution
PT100
-50 to 400°C
0.05% ± 0.5°C
0.1°C
PT1000
-50 to 400°C
0.05% ± 0.5°C
0.1°C
Accuracy specifications apply to multimeter only, they do not account for additional probe accuracy
errors.
Continuity and Diode Test
Continuity:
1000Ω range selected; audible tone sounds for impedance <10Ω.
Diode Test:
Test current approximately 1mA; displays voltages up to 1.2V.
Maximum Open Circuit
Voltage:
3.5V
Maximum Input:
1000V DC or AC rms, any range.
TRIGGER
External Remote Trigger (TTL/CMOS)
Connection:
Terminal block on rear panel.
Input:
Input to the LED of an opto-isolator through 1kΩ resistor. Apply >+3V
to trigger remote input. Max. Voltage 10V.
Output:
Opto-isolated open collector output, conducts for 250ms on
completion of input trigger. Max. off-state Voltage: 10V. On state sink
current 2mA (typical).