Instructions

ManualsBrandsAim TTi ManualsMeasurement, Diagnostics & Power Supply UnitsAim TTi 1908 Bench multimeter Digital Calibrated to: Manufacturer's standards (no certificate) Data logger CAT II 600 V,

Page 41

IAC

<CPD>

Sets the main display to ac Amps and optionally sets the range; if no range

is specified the display defaults to mA autorange.

The following <CPD> can be used to set the range:

<1MA>,<100MA>,<1000MA>,<10A>

IACDC

<CPD>

Sets the main display to ac+dc Amps and optionally sets the range; if no

range is specified the display defaults to mA autorange.

The following <CPD> can be used to set the range:

<1MA>,<100MA>,<1000MA>,<10A>

OHMS

<CPD>

Sets the main display to two wire Ohms and optionally sets the range; if no

range is specified the display defaults to autorange.

The following <CPD> can be used to set the range:

<100>,<1000>,<10K>,<100K>,<1000K>,<10M>

2WOHMS

<CPD>

Sets the main display to two wire Ohms and optionally sets the range; if no

range is specified the display defaults to autorange.

The following <CPD> can be used to set the range:

<100>,<1000>,<10K>,<100K>,<1000K>,<10M>

4WOHMS

<CPD>

Sets the main display to four wire Ohms and optionally sets the range; if no

range is specified the display defaults to autorange.

The following <CPD> can be used to set the range:

<100>,<1000>,<10K>,<100K>,<1000K>,<10M>

CONT

Sets the main display to continuity test.

DIODE

Sets the main display to diode test.

TEMPC

<CPD>

Sets the main display to Celsius temperature measurement and optionally

sets the RTD probe type; if no probe is specified the existing probe is used.

The following <CPD> can be used to set the RTD probe type:

TEMPF

<CPD>

Sets the main display to Fahrenheit temperature measurement and

optionally sets the RTD probe type; if no probe is specified the existing

probe is used.

The following <CPD> can be used to set the RTD probe type:

CAP

<CPD>

Sets the main display to Capacitance and optionally sets the range; if no

range is specified the display defaults to autorange.

The following <CPD> can be used to set the range:

<10NF>,<100NF>,<1UF>,<10UF>,<100UF>

FREQ

<CPD>

Sets the main display to Frequency and optionally sets the range; if no

range is specified the display defaults to autorange.

The following <CPD> can be used to set the range:

<100HZ>,<1000HZ>,<10KHZ>,<100KHZ>

AUTO

Sets the main display to autorange, except for Continuity or Diode check.

MAN

Sets the main display to manual, i.e. the current range is ‘locked’.