User`s manual

Note that a small amount of noise during rotation of the presence control is normal, and is
due to a small DC voltage present on the control. This was deliberately done, in keeping
with the "old-style" presence control circuitry that we feel sounds best.
Pilot lamp:
The pilot lamp lights when power is applied to the amplifier and the power switch is on.
The pilot lamp features a screw-on “jewel” that can be removed from the front panel to
replace the bulb without having to remove the chassis. The bulb is a standard #47
“bayonet” style bulb, available at most electronics supply stores.
Power switch:
The Power switch turns the amplifier on in the up position and off in the down position.
Glory switch:
What good is power without the glory? The Glory switch allows muting of the amplifier
output when not in use. When the switch is in the up position, the amplifier is on, and
when it is in the down position, the amplifier is on standby. The tube filaments remain on
and warmed up, so the amplifier is ready to play as soon as it is taken off standby. The
correct powerup sequence is to turn the amplifier on with the power switch and then, after
it has had time to warm up, the Glory switch is turned on. When turning the amplifier off,
the Glory switch should first be turned off, then the power is turned off after a few
seconds.