User`s manual

Front Panel Controls and Switches
Input jack:
Plug your guitar in here and you are ready to rock!
Ch1/2 select switch:
This switch selects either the clean channel or the distortion channel. It should be in the
“up”, or channel 2 position to enable normal footswitch operation, as it will override the
footswitch setting. The red and green channel indicator LEDs will alternately illuminate
when their channel is selected.
Ch 2 gain switch:
This switch turns on the gain boost function of channel 2. It should be left in the
“up”, or boosted position to enable normal footswitch operation, as it will override the
footswitch setting.
Ch 1 bright switch:
This switch changes the voicing of channel 1 to make it brighter for more high end
“sparkle”. Unlike the bright switches on most amplifiers, it does not lose effectiveness as
the volume is turned up.
Ch 1 Gain:
This is the clean channel gain control. It is primarily designed to compensate for guitars
that have lower output single-coil pickups or high-output humbuckers. Turning the gain
all the way up will give a bit of crunch with higher-output pickups if desired, or a more
even clean tone when switching between lower-output single-coils and higher-output
humbuckers in the same guitar. For the cleanest possible tone, turn the channel 1
Master up all the way and use the channel 1 Gain control as the overall channel volume.
For the most clean sustain, turn the channel 1 Gain control all the way up and use the
channel 1 Master to control the overall volume.
Channel 1 Bass:
The bass control adjusts the low frequency equalization of the clean channel.
Channel 1 Middle:
The middle control adjusts the midrange frequency equalization of the clean channel.