User's Manual
14
Problem
Solution
Product does not
switch on
1. Check the power adapter is properly
connected to the device and wall outlets.
2. Swap the power adapter to check if the
problem is caused by a defected adapter.
3. Double check if the monitor unit and
camera unit is powered on. (Refer to
section 3 of this user manual)
Screen shows 'Signal
lost ! Establishing
connection'
It indicates that the monitor unit cannot
communicate with the camera unit.
'1. Check the current camera number if it is
correct. The camera number is displayed
at the camera icon located at top left corner
of screen.
2. If you are not sure about the camera
number, press left arrow key to cycle
through each camera from number 1 to 4.
3. Make sure the camera is powered on.
The blue power LED should be lighted up.
4. If all fail, it may due to connection issue.
Please check below column for the tips.
Connection issues
Below are the tips to improve the
connectivity between monitor and camera
unit
1. Place both monitor and camera unit 3
feet above ground.
2. Flip the antenna out of the monitor unit.