Instruction Manual

3
5. Insert the rectangular tubes with
the arm pads into the frame
(Figure 7) and set to the desired
height. Lock these in position using
the thumb wheel (Figure 8).
6. Open the seat bar lock and fold
the chassis of the walker outwards
by pressing down on both sides of
the seat until it clicks into place
7. Install the brake and handle
assembly into the arm pad bar
(Figure 9) and set it to the desired
depth. Lock these in position by
dropping the hex bolt through the
hexagonal hole on top of the of
the bar just in front of the arm
rest. Place the curved washer over
the bolt on the underside of the
bar and secure using the
thumbwheel (Figure 19).
8. To adjust the distance between
the brake handle and the arm rest,
completely remove the bolt and move the assembly to the
required position. Replace the the bolt as step 7.
9. Attach the bag using the velcro fasteners on the suspension
device and the lower part of the frame (Figures 11-13).
10. To fold the walker together, remove the bag or completely empty
it and pull the strap handle on the seat upwards. Use the seat bar
lock to secure the rollator in its folded position.