Operation Manual

Fixing and Maintenance Instructions Ver.1 12/2012 (2758)
3
ASSEMBLY INSTRUCTIONS
1. Carefully remove all packaging. Check the product thoroughly for
damage or obvious faults.
If you suspect the unit to be faulty, please do not use, but contact your
supplier immediately for service.
2. Carefully insert the brake assembly (fig. 1) within the frame.
3. Ensure when brake assembly is inserted that both brakes are even in
height and the tri-walker is sitting evenly on the ground.
4. Insert screw through brake assembly into main frame via locating holes
as per Fig. 2 at the height required.
5. Fig. 4b shows the correct assembly. The screw should be inserted into
the six-sided hole as shown in Fig. 4a. The six sided hole is located on
the inside of the frame.
6. As per Fig. 3 and Fig. 3a add plastic washer and hand tighten plastic
thumb wheel.
7. It is very important that the side locking knobs (see fig.3a) are properly
tightened so that the tube will not slip down when normal weight is
applied to the handles.
Fig. 1 Fig. 2
Fig. 3 Fig. 3a