Operation Manual

Fixing and Maintenance Instructions Ver.3 03/2013 (1326)

ASSEMBLY INSTRUCTIONS

1. Carefully remove all packaging. Check the product thoroughly for damage

or obvious faults.

If you suspect the unit to be faulty, please do not use, but contact your

supplier immediately for service.

2. Release the side locking levers (fig. 1) left and right of the frame.

3. Carefully insert the brake assembly (fig. 2) within the frame.

4. Adjust the handles to the height desired, ensuring that both brakes are even

in height and the tri-walker is sitting evenly on the ground.

5. Retighten the side lever locks (fig.1). Ensure you have tightened these locks

sufficiently so that the adjustable brake tubes will not move accidentally

and the locking levers are finger tight.

6. Fix the brake cables into the integral brake cable clip welded onto the frame

if not already assembled (fig.3).

Fig. 1 Fig. 2 Fig. 3

LOCKING MECHANISM

1. Open out the tri-walker frame by pulling the grip

handles outwards in opposite directions forming a ‘V’

shape (fig.4). Once this is completed pull/push the

central locking bracket so the plates are parallel by

using the handle mounted in the centre.

Ensure the frame is locked before using it and never

use a semi-closed position as this may lead to the

frame collapsing.

Fig. 4

2. To close your tri-wheeled walker stand behind the walker and pull the handle

towards yourself to release the lock. Then apply pressure to the outside of the

handgrips and the walker will fold. Please ensure fingers are clear of the locking

mechanism to reduce the risk of entrapment when closing the Tri-Walker.