Overbed Table VG832AA Usage and Maintenance Instructions EN
INTRODUCTION Thank you for purchasing the Overbed Table from Aidapt. BEFORE USE Carefully remove all packaging. Avoid using any knives or other sharp instruments as this may damage the surface of the product. Check the product for any visible damage. If you see any damage or suspect a fault, do not use your product, but contact your supplier for support. • • INTENDED USE The overbed table is both height and angle adjustable.
2. 3. After inspection, place the wooden finished table-top face (a) down onto a soft surface to avoid scratches. If required, insert the chrome leg brackets (b) into clamps on the wooden base (a). (fig. 1) (fig. 1) 4. Depress click release pins. (fig. 2-3) (fig. 2) 5. (fig. 3) Attach C shaped tube (d) to L shaped tube (c) using the thumbwheels. (fig 4) (fig.
(fig. 5) 7. Tighten all thumbwheels by turning clockwise before use. (fig. 6) (fig. 6) OPERATION INSTRUCTIONS To adjust the height and/or angle of the table, first loosen the two short thumbwheels by turning them anticlockwise. Adjust the table to suit and secure by turning thumbwheels clockwise.
• • • NB. Ensure thumbwheels are adequately tightened before use. NB. Ensure there is nothing on the table when adjusting. The table is not load bearing and should not be used to support objects over 15kgs (33lbs). Do not allow people to lean on the table. As the table is angle adjustable, please be careful with hot items to ensure they can not slip off the table. CLEANING Clean your Overbed Table using a mild detergent with a slightly damp, soft cloth only.
