Overbed Table VG832B/VG866B Fixing and Maintenance Instructions EN
INTRODUCTION Thank you for purchasing the Economy Overbed Table from Aidapt. These instructions should be read carefully and left with the user of the product for future reference. Please see our website user manual if you require a larger font. Please ensure this equipment is installed by a competent person. VG832B – Overbed Table with Castors Max Weight Load 15kg VG866B – Overbed Table without Castors Max Weight Load 15kg DO NOT exceed the weight limit stated – doing so could put you at risk.
ASSEMBLY INSTRUCTIONS Please examine your product for any visible damage before using/installing. If you see any damage or suspect a fault, please do not use, but contact your supplier. 1. 2. Carefully remove all packaging and ensure all loose fitments have been provided. (fig. 1) If you have purchased the VG832B (with castors) follow this step, otherwise move on to step 3. Locate the pre-punched castor holes on the base frame (fig. 2), align the castor and screw in with spanner (J) provided (see fig.3).
ASSEMBLY INSTRUCTIONS (CONTINUED) 4. 5. Align pre-punched holes in bottom of H frame with the pre-punched holes in the spigots of the U frame. Insert E-clips to lock in position ensuring it clicks in place and secure. (see fig. 6 and 7) (fig. 6) (fig. 7) Place the L shape tube onto the underside of the table top, observing the following (VERY IMPORTANT) • The riveted end of L shape tube MUST be placed onto the underside of table top (see fig. 8).
ASSEMBLY INSTRUCTIONS (CONTINUED) 6. Attach the L shaped tubes using four C-shaped brackets and eight screws. (see fig.11) Ensure that the two C-shaped brackets nearer the edge of table are between the two rivets (see fig. 12). Do not overtighten as this may cause damage to the table. (fig. 11) (fig. 12) C Bracket MUST be in between the two rivets 7. 8. Insert the free ends of L shaped tubes into the H Frame (see fig. 13). You may require assistance to align them correctly.
ASSEMBLY INSTRUCTIONS (CONTINUED) 9. 10. Raise or lower table top to desired height and tighten thumb wheels by turning clockwise to secure (see fig. 15). Ensure height is the same on both sides; otherwise, table will not be level and not safe for use. To adjust height loosen thumb wheels anti-clockwise (see fig. 16) and repeat step 9. (fig. 15) (fig. 16) OPERATION INSTRUCTIONS • • • To adjust the height and/or angle of the table, first loosen the two short hands screws by turning them anticlockwise.
CARE, MAINTENANCE AND YOUR OBLIGATION Please check the Over Bed Table periodically for any signs of damage and if in doubt contact your supplier. TECHNICAL INFORMATION Width Length Height Net Weight 400mm 600mm 610-960mm 6.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX Telephone: +44 (0) 1744 745 020 Fax: +44 (0) 1744 745 001 Web: www.aidapt.com Email: sales@aidapt.co.
