Application Guide

1 For Stickshift models-Twist off the shift knob (counter clockwise)and remove.
2 Gently lift up on the trim around the gear shift lever, disconnect the harness and
slide the rubber boot off the end of the shifter knob.
3 Gently unsnap the trim bezel from around the radio, disconnect the harnesses and
remove the trim bezel.
4 Remove the (4) 9/32 screws securing the radio to the subdash.
5 Slide the Radio forward, disconnect the harnesses an antenna lead and
remove the radio
1 Gently pry outward on dash trim panel & remove.
2 Remove (2) screws securing radio to sub-dash.
3 Pull radio forward, disconnect wire harness & antenna lead & remove radio.
2001-04 Mustang
(Mounting Tabs)
**Mustang
NOTE: Position mounting holes on kit to the top
for Explorer / Mountaineer application.
NOTE: Position mounting holes on kit to the
bottom for Mustang application.
*
**
*Explorer /
Mountaineer
2002-05 Explorer /
2002-05 Mountaineer
1. This kit may be mounted in vehicle dash with pocket on top or bottom.
2. You may have to remove the factory rear support bracket, or modify the top of the
subdash to allow for the radio or pocket to fit properly.
3. Remove the Mustang mounting tabs for these applications.
1. Pocket can be on top or bottom.
2. File the top right side of the radio subdash opening so the side is straight up
and down.
3. Remove the Mustang mounting tabs for this application.
X
X
X
X
Remove Tabs
Remove Tabs
Spacer Nubs
*See Notes
on Page 1
Spacer Nubs
*See Notes
on Page 1
7 4
NOTES:
1
998-02 Ford Expedition
1997-02 Lincoln Navigator
2001-07 Ford Escape
2005-07 Mercury Mariner
NOTES:
DASH DISASSEMBLY:
2001-04 Ford Mustang
DASH DISASSEMBLY:
2002-05 Ford Explorer/Mercury Mountaineer
NOTES:
(Mounting Spacers)
1. Pocket must be on top.
2. Attach mounting spacers to backside of mounting tabs (if desired).
3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.