Operation Manual

Identifying a Good Test Cut
10
Once you’re ready to cut, plug in the USB flash drive
via the USB-A port on the rear of the cutter. Tap the
‘Settings’ button, then ‘USB’. Select your cut file*
from the drop down.
*Accepted file type: .PLT
5
11
Move the position of the
blade by using the
on-screen arrow buttons.
Designs should start
from the top right corner
of your material. Once
the blade is in position,
tap the play button to
begin cutting.
Congratulations— you’ve cut your first design! To learn
how to apply your design, visit www.siserna.com.
Ready to use your cutter to it’s full potential?
Access advanced designer tools, inspirational projects,
tutorials, and more by downloading
Leonardo Design Studio
TM
.
SETTINGS
CUT SETTINGS
TEST CUT
Cut not deep enough
and can’t be weeded
Material and carrier
cut through
Material cut and
carrier not cut through