Instructions / Assembly

Ceramic Pedestal Bathroom Sink
Assembly Instructions
[e-mail]
361-315-7198
- 4 -
STEP 2:
Use a drill to make a hole at the mark on the wall,
and then fix the expansion bolt in the installation hole.
Install the end of the bolt for the installation basin to
the corresponding expansion bolt.
Ground
High
STEP 3:
After installing the faucet, fix the basin to the bolts
which are already installed on the wall.
Wall
Basin
Bolt
Expansion Bolt
Gasket
Nut
Inlet Pipes Fitting
Drain Connection
Silicone Seal
STEP 4:
Install the drain fittings according to the corresponding
instructions, and connect the inlet and drain pipe fittings.
Seal the bottom of the drainage with silicone.
Attention: The faucet and the water inlet and drain pipes fittings
must be firm, otherwise there may be leakage. After installation,
please be sure to confirm whether there are any defects such as
water leakage.
Silicone
STEP 5:
After installing the basin, place the column to the
corresponding position.
Coat the contact surface between the basin and the wall
and between the column and the ground with adhesive
sealing materials such as silicone.
Attention: It is absolutely forbidden to use epoxy resin glue and
other sealing materials that increase in volume after hardening.